[Top] [Prev] [Next] [Contents] [Index]

Configuring the Window Disconnect Delay

The disconnectDelay resource allows you to specify the number of seconds to wait before removing a window after disconnecting from the host. The default value is one second.

This resource is useful because you can set the disconnect delay to permit viewing of error messages displayed when the terminal emulator fails to connect to a host. For example, if a user attempts to connect to the Configuration daemon without a password, the window can be set to remain on the terminal long enough for the user to read the message that says a password is required.



[Top] [Prev] [Next] [Contents] [Index]

Send comments, suggestions, or questions about this document to the NCD Technical Publications Department by Internet e-mail. Write to us at techpubs@ncd.com.
Copyright © 1997, NCD Inc. All rights reserved.