[Top] [Prev] [Next] [Contents] [Index]

Logging Messages to a File

You can log messages to a file using the NFS protocol:

  1. Specify the filename in the diag-log-file parameter (Setup -> Change Setup Parameters -> Diagnostics -> Log File). There is no default filename or directory, so you must specify the complete pathname.

  2. The log file must be accessible through the file access table described in the NCDware System Administrator's Guide for UNIX Systems and Chapter 5, Configuring Network Services.


[Top] [Prev] [Next] [Contents] [Index]

Send comments, suggestions, or questions about this document to the NCD Technical Publications Department by Internet e-mail. Write to us at techpubs@ncd.com.
Copyright © 1997, NCD Inc. All rights reserved.